Uniden EXI5660 Series - Manual (Page 22)

2
If you make a mistake while entering a name
Use [ /tone/ ] or [#/ ] to move the cursor to the incorrect character.
Press [delete/channel] to erase the wrong character. Then enter the correct character. To delete all characters,
press and hold [delete/channel].
5) STORE NUMBER is displayed. The cursor flashes indicating that the phone is ready for
the number to be entered.
6) Use the keypad to enter the phone number; each number can be up to 20 digits. If you
need the phone to pause during the dialing sequence, press [redial/pause] to insert a
two-second delay between the numbers. You can enter multiple pauses to increase the
delay. Each pause counts as a digit. The display shows a P for every pause.
7) Press [mem]. You will hear a confirmation tone, and the following screen appears.
Memory storage is complete.
8) After about 2 seconds, the following screen displays all the speed dial memory entries.
9) Press [end] to exit memory setup mode. The phone returns to standby.
Note: When storing numbers into memory, if the handset is idle (i.e., no key is pressed) for more
than 30 seconds, it will beep rapidly, and the phone will return to standby.