Universal Electronics DVR/PVR 5 - Manual (Page 28)

28
PROGRAMMING “TUNE-IN” KEYS
FOR SPECIFIC CHANNELS (continued)
To Program A “Tune-In” Key:
1. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2. Enter 9 - 9 - 5. The CBL key will blink
twice. Then select a “Tune-In” key and press
it once.
3. Press CBL once followed by the channel
number to be programmed (e.g., 3 - 9).
NOTE: If you are programming a channel for a
Digital Cable Converter, you need to enter all
channels in a 3-digit channel format. For example,
if the desired channel is 39, then enter it as 0 - 3 - 9.
4. Press and hold SETUP until the CBL key blinks
twice, then release SETUP.
5. To add another channel, repeat steps 1
through 4, substituting the new channel to be
added in step 3.
NOTE: Programming more than three channels on the
same “Tune-In”key will overwrite previous settings.
To Clear A “Tune-In” Key:
1. On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until
the CBL key blinks twice, then release SETUP.
2. Enter 9 - 9 - 5. The CBL key will blink
twice. Then select a “Tune-In” key you want to
clear and press it once.
3. Press and hold SETUP until the CBL key blinks
twice, then release SETUP.
4. This “Tune-In” key is now clear and ready for
reprogramming (see above – To Program A
“Tune-In” Key). If desired, repeat steps 1
though 3 in this section to clear another
“Tune-In” key.
Atlas DV R/PVR Manual 3/20/03 5:00 PM Page 28