Uniden BT-1018 - Manual (Page 2)

2
Installing Your Handset
Charge the Battery
1. Unpack the handset, battery pack, and battery cover.
If the battery cover is already on the handset, press
in on the notch and slide the cover down and off.
2. Line up the battery pack connector with
the jack inside the handset. (The battery
connector will only fit one way.)
3. Push the battery pack connector in until it
clicks into place. Tug gently on the wires
to make sure the battery pack is securely
connected.
4. Place the cover over the battery
compartment and slide
it up into place.
5. Connect the AC adapter to the charger's
AC IN 8V jack and set the plug into the
notch as shown. (This adapter might
already be connected.)
6. Plug the other end of the adapter into a
standard 120V AC power outlet.
7. Place the handset in the charger with
the display facing forward. The ChArge
light should turn on.
If... Try...
the ChArge
light does not
turn on
- reseating the handset.
- checking the AC adapter connection.
- seeing if the outlet is controlled by a wall switch.
Charge the handset completely (about 15 hours) before using it.