Uniden 7000A - Manual (Page 31)

BASIC OPERATION
BASIC OPERA
TION
When a caller enters the CBT code, the DTAM alerts you with loud
beeps for 35 seconds. Then the DTAM sounds two beeps every two
seconds for 30 seconds, and one short beep every second for the
last 5 seconds. To answer the call, pick up the handset. If you
do not answer, the caller can leave a message after the outgoing
message plays and a long beep sounds.
CHANGING THE CBT CODE
The CBT code is preset to 648, but you can change it by following
these steps:
1. Hold down
code set until the DTAM beeps once appears.
2. Press The DTAM beeps and appears followed by the
digits of the preset CBT code in sequence, then the first digit
reappears. For example, when the security code is 648, the
display shows
, , , then reappears.
3. Repeatedly press or to set the first digit, then
press . The second digit appears.
4. Press or to set the second digit, then press
The third digit appears.
5. Press or to set the third digit, then press .
31
NOTE:
Be sure to set each digit within 8 seconds. Otherwise, you must start
over from Step 1.
The DTAM sounds a long beep and announces the CBT code.