U-Line 2275DWRWS - Manual (Page 7)

2275DWRWS, 2275DWRWOL 7
Figure 2
IMPORTANT IMPORTANT
Proper air flow (Figure 2) is required for your unit to
operate at its highest efficiently. A grille, located in
the base of the unit, must not be blocked at any
time, or your unit will not perform as expected.
Initial Startup
All U-Line units are shipped with controls that are preset.
No initial adjustments are required.
IMPORTANT IMPORTANT
U-Line recommends the unit be allowed to run
overnight prior to loading with product.
Figure 3
To turn the unit on or off, touch and hold the POWER icon
(Figure 3, 1) on the display panel for approximately five
seconds until the °F symbol flashes and release.
• A small LED above the icon will illuminate to confirm
the touch of any controller icon.
• The display (Figure 3, 3) will show the unit set-point
temperature when the unit is on and will show OFF
when the unit is off.
• Turning the unit off will override any other control
function.
Interior Lighting
The interior of the cabinet can be illuminated whenever a
drawer is opened (default mode) or illuminated for a
four-hour period.
The LIGHT icon (Figure 3, 5) on the control panel is used
to change the lighting functions.
To illuminate the interior of the cabinet for a four-hour
period:
1. Touch and release the LIGHT icon (Figure 3, 5) to
switch from drawer-operated lighting control to
continuous lighting (the °F symbol will flash briefly
after the LIGHT icon is pressed).
2. To return to drawer-operated lighting control before
the four-hour period is up, repeat Step 1.
5 Operation
ULIN_0080_A
1 2 3 5 4
ULIN_0184_A
ULIN_016357_30179.fm Page 7 Thursday, February 1, 2007 1:24 PM