Uniden 880 - Manual (Page 17)

17
Problem Suggestion
Using MEM/SCAN does not
access channels in memory
Verify that there are channels saved into
memory.
Unit does not work as well as
previously.
Turn the power off then back on. The channels
will reset.
Battery power check returned
FAILLO or FAILHI .
Make sure your power wires have a good
connection.
Check your battery charge; it needs to be fully
charged. Lower voltage will cause a failure.
Check your alternator.
Antenna check returned FAIL .
Make sure your antenna ground is good.
Check for damage to the antenna.
Check the SWRs at a CB shop. High SWRs will
damage the radio.
RF power diagnosis check
returned
FAIL .
Make sure your antenna ground is good.
Check for damage to your antenna.
Check the antenna connection on the back of
the radio. Be sure it is tight.
If you do not get satisfactory results after performing these checks, call
the Uniden Customer Service Center at 1-800-297-1023, 8:00 a.m. to 5:00
p.m. CST, Monday through Friday.
serviCing yoUr transCeiver
Technical information, diagrams, and charts are provided on request. It
is the user's responsibility to see that this radio is operating at all times
in accordance with the FCC Citizens Radio Service regulations. We highly
recommend that you consult a qualified radio/telephone technician for
servicing and aligning this CB radio product.
When ordering parts, be sure to specify the correct model number and serial
number of the unit.
speCiFiCations
GENERAL
Channel:
40
Frequency Range: 26.965 - 27.405 MHz
Frequency Control: PLL Synthesizer