Ultra electronic Magicard Prima 2e - Manual (Page 2)

www.ultramagicard.com
Prima 2E Cleaning Instructions
6. Remove the backing from the cleaning card.
7. Insert the card from the right hand side slot when
looking from the front of the printer, sticky side down.
8. Repeat steps 3 to 7 turning the card sticky side
up.
9. Power printer off once the cleaning card has been
discharged.
NOTE:
THE CLEANING CARD SHOULD ONLY BE USED
ONCE, DIRT WILL TRANSFER BACK TO THE
ROLLERS IF IT USED TOO MANY TIMES.
CLEANING ROLLER ASSEMBLY.
• The
sticky rollers remove dust and debris from the card surface.
• Cleaning the sticky rollers is recommended after each print run.
• Generally, cleaning is required after 100 – 200 cards, dependent on environment.
• This
operation must not be carried out during the printing process.
1. Open the card tray and remove the sticky cleaning cartridge.
2. Wash out the dirt and debris on the roller surface using mild soapy water. Do not use alcohol or detergent.
NOTE: ENSURE THE CARTRIDGE IS DRY BEFORE RE-FITTING IT INTO THE MACHINE.
3. Clean the rubber roller within the card tray assembly using the alcohol cloths supplied in the cleaning kit.
4. Replace card tray and sticky roller, power on the unit.