Uniden DSS8905 - Manual (Page 4)

3
Installing the Battery
Use only the Uniden BT-446 rechargeable battery pack supplied
with your cordless telephone.
Installing the Belt Clip
Insert the tabs on the sides of the belt clip into
the holes on either side of the handset. Press
the belt clip down until it clicks into place. (Tug
on the clip to make sure it’s secure.)
To remove the belt clip, gently pull the tabs out
of the holes, then slide the belt clip off of the
handset.
Unpack the
handset, battery
pack and battery
cover. (If the
battery cover is on
the handset, press
in on the notch and
slide the cover off.)
Push the battery pack
connector in firmly. (You
should hear it click into
place.) Gently tug on the
battery wires to make sure
the connection is secure.
BLACK
RED
Line up the red and black
wires on the battery pack
connector with the sticker in
the handset’s battery
compartment.
Place the cover over the
battery compartment and
slide it up into place.