Perreaux SM6 MKII - Manual (Page 6)

6
1 1 1 1
Unpacking and Placement
The SM 6 is packaged for maximum protection. Please carefully read the
instructions below before proceeding to unpack the unit. Be extremely careful.
Unpacking
Procedure
Inspect both ends of the cardboard box and open at the end without the
central staple by slitting the reinforced tape at either side.
Fold back the flaps and tip the package on end and the inner box will
slide out.
Lay the inner box down flat and upright, open it conventionally by
separating the top tray from the bottom.
The product can now be removed from the bottom packaging. This will
be easier if you have someone to help you by holding the base of the
box.
Alternately, the bottom tray and preamplifier could be tipped upside
down and the bottom packaging removed. If opened in this manner,
please ensure that you turn the contents over again.
Note: Be very careful to secure the unit if you are planning to flip the package
upside down.
Remove the two grey foam protectors off either side of the unit, leaving
the black material covering.
Pull back the material and remove the protective membrane from the
front panel.
The preamplifier is now unpacked and ready for further installation.
Note: Please retain all packaging material for future transport.
Box
Contents
1 x SM 6 M kII Preamplifier 1 x Screwdriver
1 x SM 6 M kII Product manual 2 x Remote trigger leads
1 x Perreaux remote control 1 x Detachable AC power cord
2 x AAA batteries 3 x Performance analysis charts
Placing
Your SM6
The SM 6 should generally be placed close to your amplifier, keeping the
interconnect cabling short. Position all the separate components of your system
close enough to your SM 6 to avoid having to stretch or extend any of the
interconnect cables.
As a “rule of thumb”, allow 80-100mm (3-4 inches) around all sides of the
product and mount the SM 6 on a flat surface, ensuring that the unit has adequate
access to free flowing air.
Do not place auxiliary equipment directly on top of the SM 6.
Do not place the SM 6 directly atop a power amplifier.
Please do not cover the product with a cloth or similar.