Troy-Bilt Bronco - Manual (Page 12)

Throttle Control Lever
The throttle control lever is located on the right side of the
tractor’s dash panel. This lever controls the speed of the engine
and when pushed all the way forward, the choke control also.
When set in a given position, the throttle will maintain a uniform
engine speed. See Fig. 4-2.
IMPORTANT: When operating the tractor with the cutting deck
engaged, be certain that the throttle lever is always in the FAST
(rabbit) position.
Brake Pedal
The brake pedal is located on the right
front side of the tractor above the drive
pedal along the running board. The
brake pedal can be used for sudden
stops or setting the parking brake.
NOTE: The brake pedal must be fully
depressed to activate the safety
interlock switch when starting the tractor.
Ignition Switch
The ignition switch is activated to start the engine. Insert key
into the ignition switch and turn clockwise to the START position.
Release the key into the ON position once engine has fired. See
Fig. 4-3. The engine will run with the headlights on.
To stop the engine, turn the ignition key counterclockwise to the
OFF position. See Fig. 4-3.
FAST
SLOW
CHOKE
Figure 4-
Figure 4-3
Off
Start
On/Lights
1 s
ectiOn
4 — c
OntrOls and
f
eatures