1 add – TP-Link TL-SF2226P User Manual
Page 12
TL-SF2226P+/TL-SL2226P+
Remote Smart Switch User Guide
are four steps on configuring the switch.
1) Add
2) Connection
3) Configuration
4) Exit
Caution:
When you use the switch for the first time, you must reset the IP address and
gateway of the switch. The witch default IP address is 192.168.0.100(for more details,
please refer to Chapter 5).
Here are details on how to use the SSU application.
Before configuration, make sure that the PC and the switch which the SSU application
installed can see each other. You can ping the switch, check whether they can see each
other. If they can't see each other, check whether the power is on and the twisted pair is
well connected. If all is ok, run the SSU application, you can see the initialized interface
of the SSU application. As figure 5-2.
Figure 5-2
5.2.1 Add
1) First, add a device group. The name of the new group can't be the same as the
names that already existed in the application. After adding the group, you can
rename the group and delete it at any time. Here are some methods as follows.
a) Click main menu->System->Add Group. As figure 5-3.
- 9 -