Asus GigaX1024X - Manual (Page 7)

6 ASUS GigaX1024X
English
Connecting network devices
To connect network devices to the GigaX1024X switch:
1. Connect one end of the Ethernet cable to an Ethernet port on the
switch front panel. Connect the other end to the Ethernet port of the
network device. Repeat this step to connect additional network devices.
2. Plug one end of the power cable to the power connector on the switch
rear panel, then plug the other end to an electrical outlet.
3. The Power LED and LED indicators for active Ethernet ports light up to
indicate that the device is on and in use. Refer to the front panel Label/
LED table in page 4 for LED indications.
NOTES
• We recommend the use of Category 5 Ethernet straight-through
cables to ensure proper connections between the switch and other
network devices.
• You may use the switch Ethernet ports as an uplink to another
switch, hub, bridge or repeater. The switch is capable of detecting
either cross-over or straight-through cables.
POWER
100M
10M
SPEED TRANSMIT/RECEIVE
FULL DUPLEX COLLISION
STATUS / SPEED
DUPLEX / COLLISION
10 BASE-T / 100 BASE-TX
10/100 Fast Ethernet Switch