Toastmaster 3348/3348MEX User Manual

Page 6

3. Fill Detachable Water Tank, see “FILLING THE DETACHABLE WATER

TANK.”

4. Plug into a 120V ~ 60Hz outlet. The Power Light will turn on and

remain on as long as the Steam Station Iron is plugged in. The Heating

Light will continue to cycle on and off during use.

5. Adjust the Temperature/Steam Control to desired setting or MAX for

maximum steam.

6. When you press the Steam Button, the electric pump (located in the

Base) will supply water to the iron and steam will start to emerge.

7. If you require a constant flow of steam, push the Steam Button Lock

forward to hold the Steam Button in place. You can stop the flow of

steam either by releasing the Steam Button Lock and sliding it back or

by pressing the Steam Button. Note: The Steam Station will make a

humming sound when the Steam Button Lock is engaged.

NOTE: When the Steam Button is pressed for the first time, the electric

pump may make a noise. This is normal sound as the electric pump is

being primed with water. The noise will decrease and after 1-1

⁄

min-

utes and steam will emerge.

8. The Iron will release steam in the horizontal and vertical positions.

9. When finished, move the Temperature/Steam Control to MIN. Unplug

from outlet and allow to cool before storing Steam Station.

10. Remove Detachable Water Tank and Filter and empty completely.

Replace Filter into Detachable Water Tank. Replace Detachable Water

Tank into Base.

NOTE: Do not use the Steam Button Lock in the lock position for more than

20 minutes. Usage over 20 minutes may cause water leakage from the

soleplate.

VERTICAL STEAMING

1. To vertically steam fabrics, follow steps 1-4 in “IRONING WITH

STEAM.” Plug Steam Station into a 120V ~ 60Hz outlet. Adjust the

Temperature/Steam Control to MAX.

2. Once the iron has reached MAX setting, hold the iron horizontally and

press the Steam Button until steam begins to emerge. Then hold the

iron vertically with the iron facing the fabric to be steamed. The iron

should be kept 1 - 2 inches from the fabric.

3. If you require a constant flow of steam, push the Steam Button Lock

forward to hold the Steam Button in place. You can stop the flow of

steam either by releasing the Steam Button Lock and sliding it back or

by pressing the Steam Button.

4. While using the vertical steaming feature, be sure to keep an adequate

supply of water in the Detachable Water Tank.

5. Follow steps 9 and 10 in “IRONING WITH STEAM.”

MAINTENANCE

This Steam Station requires little maintenance. It contains no user service-

able parts inside the base.