TANDBERG 3.0 - Manual (Page 30)

Copyright © TANDBERG 2008 Reference Guide Version 3.0 rev 3.0 26
Parameter Type Comments
important (optional) Boolean This setting should not be present if
operationScope is "configuredState". Specifies
whether this participant is important.
audioTxMuted Boolean This setting should not be present if
operationScope is "configuredState".
borderWidth (optional) Integer 0 (no border), or 1, 2, or 3 for +1/+2/+3.
focusType (optional) String One of:
voiceActivated
,
h239
or
participant
.
focusParticipant (optional) Struct A participant identification structure (i.e. with
conferenceName, participantName,
participantProtocol and participantType
members). Should only be present if focusType is
participant.
If there is no operationScope parameter, the MCU will attempt to change both active and configured states.
This is deprecated behaviour, and should not be relied upon.
4.13 participant.connect
This method is used primarily for API-configured participants with deferConnection set to true, but can also be
used to reconnect disconnected participants.
Parameter Type Comments
conferenceName String
autoAttendantUniqueId String
participantName String
participantProtocol String
participantType String Participant identification as described above.
4.14 participant.disconnect
Parameter Type Comments
conferenceName String
autoAttendantUniqueId String
participantName String
participantProtocol String
participantType String Participant identification as described above.
This call causes the MCU to tear down its connection to the specified participant, if such a connection exists.
This is different from “participant.remove” above because:
f in the case of configured participants, it does not remove the configuration (thus allowing later re-
connection with “participant.connect”)
f in the case of ad hoc participants, it does not remove the record of the previous connection
4.15 participant.move
This method is used to move a participant from one conference to another.
Parameter Type Comments
conferenceName String
autoAttendantUniqueId String
participantName String Participant identification as described above.