TRENDnet TV-IP100 - Manual (Page 8)

14
Rear Panel
Network Cable Connector
The Internet Camera’s rear panel features an RJ-45 connector for
connections to 10Base-T Ethernet cabling or 100Base-TX Fast
Ethernet cabling (which should be Category 5 twisted-pair cable).
The port supports the Auto MDI-X type, allowing the Internet
Camera to automatically detect or negotiate the transmission
speed of the network.
DC Power Connector
The DC power input connector is located on the Internet
Camera’s rear panel, and is labeled DC 5V with a single jack
socket to supply power to the Internet Camera. Power will be
generated when the power supply is connected to a wall outlet.
Network Cable
Connector
DC Power
Connector
Reset Button
10/100 Ethernet
DC 5V
Reset
15
Reset Button
Reset will be initiated when the reset button is pressed once, and
Power LED begins to flash.
Factory Reset will be initiated when the reset button is pressed
continuously for three seconds or when Power LED begins to
light up. Release the reset button and the Power LED will begin
to flash, indicating the Internet Camera is changing to factory
reset. The IP address will also return to the default setting as
192.168.0.20.