Therma-Stor Products Group TS-285 - Manual (Page 3)

3 www.thermastor.com • [email protected] Toll-Free 1-800-533-7533
• Vérifier la protection du différentiel avant chaque
utilisation en appuyant sur le bouton “ test “. Si
l’appareil fonctionne correctement, le bouton “ reset “
ressort.
• Avant de laisser un appareil aéraulique axial sans
surveillance, s’assurer que les enfants n’ont pas accès
à l’équipement. Ne pas laisser les enfants jouer avec
l’appareil ou à proximité de l’appareil ou dans l’air qu’il
projette.
• Pour réduire le risque d’incendie ou de choc électrique,
ne pas utiliser ce ventilateur avec un dispositif de
commande de vitesse à semi-conducteurs.
2 Intended Application
The Phoenix Axial Air Mover has changed the drying
industry by minimizing overall drying time on water
restoration jobs. The Phoenix Axial Air Mover uses patent
pending FOCUS Technology to maximize air velocity across
floors and along walls for longer distances. By maximizing
the air velocity, water evaporates more quickly from the
carpet, pad, sub-floor, wall, and sill plate.
3 Safety Certifications
The Phoenix Axial Air Mover (P/N 4025200) conforms to
UL STD 507. Certified to CAN/CSA STD C22.2 No. 3.
4 Specifications
Part No. 4025200
Power /4 hp -phase 0/20 VAC 2-speed
4-pole, PSC Electric Motor.
CFM Approximately 3000
Cord 20 ft Power Cord
Outlet 5A UL Rated GFCI Duplex Receptacle
Current Draw 2.5 Amps
Voltage 5 VAC
Warranty Year One - 00% parts and labor
(all components)
Year Two - 00% parts only (all components)
Years Three through Seven - Only materials
and workmanship of the housing are covered.
Dimensions
Cabinet
Width 9.9”
Height 9.5”
Depth 5.2”
Weight 29.5 Lbs
5 Power Requirements
5.1 Daisy Chaining
The Phoenix Axial Air Mover draws 2.5 amps. The 2 amp,
on-board circuit breaker will allow four (4) Phoenix Axial Air
Movers on one circuit. When daisy-chaining the Phoenix
Axial Air Mover, turn on one Phoenix Axial Air Mover at a
time to prevent excessive current inrush caused by four
units starting at once.
A ground fault in the Phoenix Axial Air Mover or anywhere
on the circuit will cause the Axial Air Mover’S GFCI to trip.
After rectifying the ground fault, reset the GFCI by pressing
the reset button.
Figure 1: Too many Axial Air Movers daisy-chained
Figure 2: Duplex GFCI use
5
15 Amp
Outlet
15 Amp
Outlet
15 Amp
Outlet
Phoenix 200 MAX
Phoenix Mini-Guardian
5.2 Recommended Use
Recommended use(s) of on-board duplex GFCI are shown.
Note: Standard 115 VAC electrical outlets.