beautypg.com

Approvals, Cable vfx-250s – TANDBERG D11624 User Manual

Page 12

background image

Tandberg

Video on Frame Relay

D11624 rev.01

12

8. Approvals

FCC Class A Digital Devices and Peripherals
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.

A note about system cables:
To maintain the EMC (ElectroMagnetic Compatibility) performance of the unit, user and
network port cables must be high quality, fully shielded cables with EMI/RFI connector
hoods.

9. Cable VFX-250S

In order to cable the VFX-250S into a frame relay network, you need to assemble the
following cables according to your network requirements:

Console Cable

Network Cable

User Cable

Refer to Appendix A, Cables and Pinouts, for pinouts and wiring diagrams. Plug the +5
VDC power supply into the VFX-250S and plug the supplied power cord into the power
supply and a standard AC outlet. Only use the power supply provided by Science
Dynamics (P/N LZUSD02001A0200). Connect the VFX-250S console port to a terminal
or PC communications port to configure and maintain unit settings. For a video-
conferencing application, install the VFX-250S in the frame relay network between the
network (FRAD) equipment and the user (video codec) equipment. Please see User
Manual for technical details.