Groupe SEB USA - T-FAL Electric Grill CB6010 - Manual (Page 12)

After use
Set the thermostat to the Min. position.
Unplug the cord from the mains: the pilot light goes out.
Next, remove the control unit (4) from the appliance
by pressing on the latch (5) to unlock it.
Allow the appliance to cool.
Withdraw the locking strut (6) and clip it to the
cover (1).
Remove the protective cover (1) from the appliance
by opening it to mid-height and then lifting it from the
back of the appliance.
The protective cover (1), the grill plate (2) and the
juice drip tray (3) may be cleaned with a cloth, hot
water and washing up liquid.
Never use a metallic sponge or scouring powder as this could
damage the non-stick coating inside the protective cover (1)
and on the grill plate (2).
The grill plate (2) may be easily cleaned without any risk
when the control unit (4) is removed from the appliance.
While cleaning the appliance, make sure you do not twist the
pins of the heating element.
Never immerse the appliance, the control unit (4) or the
cord in water.
Storage
Insert the drip tray (3) in the front of the appliance,
under the grill plate (2).
Insert the protective cover (1) at the back of the
appliance, as shown in the drawing opposite.
Close the protective cover (1) to protect the grill
plate (2).
The protective cover (1) will not close correctly while the
control unit (4) is inserted in the appliance.
Do not insert the control unit (4) in the appliance.
Store the appliance and control unit (4) in a dry place.
Never store the appliance in direct sunlight or leave it
outside during winter.
Largo table +TK 03/05 14/3/05 15:04 Page 36