TC Electronic NonLin2 TDM - Manual (Page 6)

EE
NN
GG
LL
II
SS
HH
6 / NonLin2
• Select the Focus Field you wish to link a parameter to, by clicking on that field.
• Click on the parameter you wish to link to the selected Focus Field.
• To get an unassigned (empty) Focus Field, click again on the selected parameter.
• Once you have finished the assignments, click again on the Assign button to leave
the assign mode.
OVERLOAD INDICATION (O/L)
The two LEDs in the metering section, between the input and output meters, will light
up in case internal DSP overloads are detected. You should lower the input level to
avoid these overloads. To reset the indication, click on the O/L LED.