Setting the identification code, Optical mouse – Targus AKM10US User Manual

Page 5

Text mode
Original mode

Targus wireless keypad and opitcal mouse combo

Setting the Identification Code

After your computer detects the USB receiver you must set
the ID code between the receiver and the mouse as well as
between the receiver and the keypad BEFORE you can use
them. To do this, do the following:

NOTE: MAKE SURE THAT YOUR COMPUTER IS TURNED ON AND HAS DETECTED

THE USB RECEIVER BEFORE YOU SET THE ID CODE.

Optical Mouse

1 Plug the USB receiver into an available USB port on your
computer. The LED on the receiver will flash for 60 seconds to
indicate ID search mode.

2 Press the setup key on the bottom of the mouse.

Setup Key

Power switch

When the LED on the receiver is lit, the mouse is set up with
an ID and the receiver is locked.

You are now ready to use the mouse.

Proceed to setting the ID code with the keypad.