Tanaka TPH-200 - Manual (Page 4)

www.tanakapowerequipment.com 3 [email protected]
Owner’s Manual TPH-200
2. Assembly procedures
Installation of cutting attachment (Fig. 2-1)
1. Remove gear case from your brush cutter.
2. Join the attachment in place of it.
NOTE!
If your brush cutter tube is 26mm diameter, remove bracket
collar B (4) from the attachment.
3. Make sure the locking bolt (1) fits in the location hole (2)
of tube and that the tube will not come off.
4. Tighten the clamp bolt (3) securely.
WARNING!
During operation, hold the unit firmly with both hands. A single hand operation may
cause serious injury.
Adjustment of blade angle (Fig. 2-2, 3)
WARNING!
Always stop engine before making adjustments.
Never touch the blade when adjusting blade angle. Hold the support handle (3) instead.
1. Stop the engine.
2. Loosen wing nut (1) and knob nut (2) slightly so that the support handle (3) slides.
3. Adjust the blade angle to desired position by holding
the support handle (3).
4. Then, finger-tighten the knob nut (2) securely and
also the wing nut (1).