Texas Instruments TravelMate 2000 - Manual (Page 155)

BIOS messages
Hard disk failure Reboot. If that doesn’t work,
run the DIAG program to check the
hard disk drive, then contact your
Texas Instruments dealer.
Hard disk read The hard disk is defective - Reboot.
failure If that doesn’t work, run the DIAG
program to check the hard disk,
then contact your Texas
Instruments dealer.
Invalid Memory size is incorrectly
Configuraition configured, or
information Display adaptor is incorrrectly
configured, or
Incorrect number of floppy
drives - Check the settings on the
Set Up and Hardware Installation
screens (see Chapter 4).
Keyboard clock/data Either the keyboard or the external
line failure keyboard cable connection is
defective - Make sure the keyboard
cable is connected properly.
Keyboard stuck key One or more keys are jammed - Try
failure pressing the key again. Run the
DIAG program to check the
keboard keys.
No boot device The floppy drive, the hard disk, or
available the floppy itself is defective -
Reboot If that doesn’t work , replace
the floppy. If the hard disk is faulty,
run the DIAG program, then
contact your Texas Insruments
dealer.
No boot sector on The hard disk is not
hard disk formatted - Format the hard disk.
Remember that this will erase all
contents of the hard disk.
Not a boot diskette. The floppy in the optional Floppy
Drive Unit is not formatted as a
bootable floppy - Replace the floppy
with a bootable floppy, then reboot.
G-2 B10S Messages