Transition Networks CPSFM-200 - Manual (Page 3)

Trademark Notice
All trademarks and registered trademarks are the property of their respective owners.
Copyright Restrictions
© 2000, 2004-2005 Transition Networks.
All rights reserved. No part of this work may be reproduced or used in any form or means
(graphic, electronic, mechanical) without written permission from Transition Networks.
Printed in the U.S.A.
33193.C
Compliance Information
CISPR22/EN55022 Class A & B
CE Mark
FCC Regulations
This equipment has been tested and found to comply with the limits for a Class A&B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference, in which case the user will be required to correct
the interference at the user's own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A&B limits for radio noise for digital
apparatus set out on the radio interference regulations of the Canadian Department of
Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites
applicables aux appareils numériques de la Class A&B prescrites dans le Règlement sur le
brouillage radioélectrique édicté par le ministère des Communications du Canada.
Declaration of Conformity
Name of Mfg: Transition Networks
6475 City West Parkway, Minneapolis MN 55344 USA
Model: CPSFM-200 Fan Module
Part Number(s): CPSFM-200
Regulation: EMC Directive 89/336/EEC
Purpose: To declare that the CPSFM-200 to which this declaration refers is in
conformity with the following standards.
CISPR 22: 1993; EN 55022:1998 Class A&B; EN 55024:1998
I, the undersigned, hereby declare that the equipment specified above conforms to the above
Directive(s) and Standard(s).
_July 8, 2000_____
Stephen Anderson, Vice-President of Engineering Date