TAG DVD32FIR - Manual (Page 24)

programming the system remote
|
47 46
|
programming the system remote
Macros can only be programmed with either av or sat selected!
Macros programmed under av will be recalled, pressing m1, m2, ...
m4 or standby, when you use av, cd, dvd, or amp. Macros
programmed under sat will be recalled when using sat, tv, vcr and ld.
When using the macro functions, it can take up to 10 seconds to
transmit a 10-key sequence. You should keep the system-remote
pointing towards the appropriate unit while the commands are being
transmitted to ensure they are received correctly.
To program in a macro function:
1. Simultaneously press the REMOTE SELECTION key for the set of
macros you wish to program (av or sat) and the mute key. The
learning status LED and the REMOTE SELECTION key will both
turn red to indicate that the Remote is in macro learning mode
(1) .
2. Press one of the macro keys m1 to m4 or standby to which you
wish to allocate the functions.
3. Press the keys for the commands (up to 10) you want stored in
the macro key (2) .
4. Press the CH + (or CH -) key to store your selections. The
learning status LED and the REMOTE SELECTION key will both
flash red twice, then go out.
5. To use the macro, simply press the macro button.
1. The Remote will stay in macro learning mode for 20 seconds, after which it will return to normal operation mode if there have been no
further key presses
2. You can select functions to control another unit as part of a macro by first pressing the appropriate REMOTE SELECTION key before
pressing the keys for the desired functions. This REMOTE SELECTION key press counts as one of the 10 presses you may store in the
macro key
programming a macro function
m1 m2 m3 m4
light
cd
vcr tv
ld
sat
dvd
tuner
md
aux
dab
--- ---
+ +
--- ---
V O L C H
cd dvd amp
R E M O T E S E L E C T I O N
sat tv vcr ld
av
mute
7. Once you have finished teaching the system-remote all the
desired commands from the original remote, you must store
them by simultaneously pressing the appropriate REMOTE
SELECTION key and the ok key for about four seconds.
Once you have stored the ‘learnt’ functions, test the keys you have
taught to make sure that they are programmed correctly.
If the system-remote has problems learning from the original
remote
(1) ,you should:
• check that the original remote has fresh batteries
• avoid fluorescent lights and strong sunlight, which may interfere
with the learning process
• increase or decrease the distance between the two remote
controls (within a range of 2 to 15cm / 1 to 6in)
learning new commands (cont’d)
programming macro features
The keys m1 to m4 and standby can act as macro keys. These can
be programmed to store up to 10 commands to send together with
one key press. Any key press function (except mute, CH + and CH –)
can be programmed into the macro keys. There are 2 groups of
macros, one used if the av, cd, dvd or amp remote selection keys
have been pressed, the other for the sat, tv, vcr or ld keys; i.e. there
are a total of 10 macros available.
1. Some remote controls operate at non-standard infra-red, UHF or ultrasonic frequencies, and cannot be learnt; this is sometimes also
caused by unusual or complex functions which are not universally recognised. If you continue to experience problems programming the
system-remote, please consult your retailer for advice
m1 m2 m3 m4
light
cd
vcr tv
ld
sat
dvd
tuner
md
aux
dab
--- ---
GRR00868.01-DVD32RFLR UM 5/30/02 12:26 PM Page 46