Troy-Bilt 41 AM079G063 - Manual (Page 6)

6
Section 2
Assembly
(4) Screws
Shaft
Housing
D-Handle
Bottom Clamp
Fig. 2-1
(4) Nuts
Shaft Grip
INSTALLING THE BRUSH CUTTER KIT
The Brush Cutter Kit consists of:
• J-handle and hardware
• Harness
• New cutting attachment mount
• New cutting attachment shield
• Cutting blade
• Blade retainer and nut
• Locking Rod
The D-handle and old cutting attachment shield must
be removed and replaced. All other kit items must
assembled before using the unit with the cutting blade.
To avoid serious personal injury or damage to the
unit, ALL of the items in the brush cutter kit
MUST be installed when operating the unit with
the cutting blade.
SYMBOL MEANING
• BRUSHCUTTERS • Replace dull blade.
Do not sharpen the cutting blade. Sharpening the blade can cause the blade tip to
break off while in use. This can result in severe personal injury.
• TRIMMER/BRUSHCUTTER SAFETY
WARNING: Thrown objects and rotating cutter can cause severe injury. Keep
bystanders, especially children and pets, at least 50 feet (15 m) away from the cutting
area. The cutting attachment shield must be used when using the trimmer
cutting attachment.
WARNING: The operation of any power tool can cause foreign objects to be thrown
into your eyes. This can lead to severe eye damage. Before commencing power tool
operation, always wear safety glasses or goggles that are marked as meeting ANSI
Z87.1 standards, and a full face shield when needed.
Safety (continued)
REMOVE THE D-HANDLE
Remove the D-handle before assembling the
J-handle.
1. Remove the four (4) screws and four (4) hex nuts
with a Phillips screwdriver.
2. Remove the D-handle and bottom handle clamp on
the boom shaft (Fig. 2-1).