Perreaux Headphone Amplifier Silhouette SXH2 - Manual (Page 7)

6
2 2 2 2 Instant Install
If you are like us, the first thing you will want to do is to play
your favourite piece of music through your new SXH2. The
following instructions are written to enable you to achieve this as
quickly as possible. These are not comprehensive instructions,
but are designed to enable you to play music now!
Note: Please take the time to read the SXH2 manual thoroughly
as it incorporates many features, which will enhance its
operation.
Placement
The SXH2 is a sensitive low power amplifier and best results
will be achieved when placed away from potential interference
from other components and electrical devices, for example AC
mains cords/outlets, transformers, high power amplifiers,
computers, etc.
Place the SXH2 close or near the source component in order to
make as short a connection as possible.
Turn off associated components
This minimises the potential to damage any other components
when connecting your SXH2 into the system.
Connect source to SXH2
Connect the audio output from the source component to the
inputs at the rear of the SXH2. Refer to Chapter 4 for Rear Panel
information.
Connect headphones to SXH2
Connect a set of headphones to one of the jacks on the front
panel. Refer to Chapter 3 for Front Panel information.
Note: Make sure the nominal impedance of the headphones is
not lower than 8Ω.
Switch on SXH2
Insert the power cord supplied into the rear of the SXH2 and into
the wall. Switch on the socket at the wall and turn on the power
of the SXH2 by setting the power switch down.