Toshiba TCB-AX21UL - Manual (Page 8)

Wireless remote controller kit
Installation Manual
– 7 –
4. Use bracket parts (A) and (B) to securely grip the ceiling
material. (Fig. E)
5. Connect the Signal receiving unit wire (2-core) to the wire
from the indoor unit. (Refer to “Wiring the Signal receiving
unit.”) Check the terminal number on the indoor unit
before wiring the Signal receiving unit and be sure not to
wire incorrectly. (The unit will be damaged if high voltage,
such as 208/230 VAC, is applied.)
6. Adjust the provided spacers so that they are several
millimeters larger than the thickness of the ceiling
material. Pass the 2 supplied screws (0.16” x 1.6” (M4 x
40 mm)) through the spacers and tighten them enough to
hold the Signal receiving unit in place.
7. Return parts (A) and (B) through the gap between the
ceiling and Signal receiving unit so that they are
contained in the openings. Then tighten the screws.
Do not tighten the screws excessively. This may result in
damage or deformation of the case.
Tighten to the point where the Signal receiving unit can be
moved slightly by hand. (Fig. F)
8. Reattach the face plate.
Part (A)
Fig.E
Part (B)
Fig.F
7-EN
+00EH99677601_01EN_remo_IM.book Page 7 Thursday, October 8, 2009 4:12 PM