Transcend Information TS2G-8GCF266 - Manual (Page 15)

T T T S S S 2 2 2 G G G ~ ~ ~ 8 8 8 G G G C C C F F F 2 2 2 6 6 6 6 6 6
266X CompactFlash Card
Transcend Information Inc. 15
Ultra DMA Electrical Requirements
Host and Card signal capacitance limits for Ultra DMA operation
The host interface signal capacitance at the host connector shall be a maximum of 25 pF for each signal as measured at
1 MHz. The card interface signal capacitance at the card connector shall be a maximum of 20 pF for each signal as
measured at 1 MHz.
Series termination required for Ultra DMA operation
Series termination resistors are required at both the host and the card for operation in any of the Ultra DMA modes. Table
13 describes typical values for series termination at the host and the device.
Table: Typical Series Termination for Ultra DMA