Problem: tv does not work – Team Products PMP1200 User Manual
Page 5
PMP1200 Models
Owner’s Manual
Reason
Solution
Poor contact with
Clean terminals
battery terminals.
thoroughly. Reattach
battery clips.
Using incorrect type of
Use true RMS reading meter.
voltmeter to test
output voltage.
Reason
Solution
Battery voltage below
Recharge or replace battery.
10.0 ± 0.5 volts.
Equipment being operated
Use a higher capacity inverter
draws too much power.
or do not use this equipment.
Inverter is too hot (thermal
Allow inverter to cool.
shutdown mode).
Check for adequate ventilation.
Reduce the load on the
inverter to rated continuous
power output
Unit may be defective.
See Warranty and call
Customer service at
1-888-231-4022.
Troubleshooting
PROBLEM: Low or No Output Voltage
PROBLEM: Red LED On
7
Reason
Solution
Electrical interference from
Add an AC interference filter on
the inverter.
to the TV power cord. Refer
to TV and audio section of
this manual.
Reason
Solution
TV does not turn on.
Try turning the inverter
ON/OFF/ON.
Contact TV manufacturer for
start up surge and power
consumption.
A larger inverter may
be required.
PROBLEM: TV Does Not Work
Reason
Solution
Input voltage below 10.5 ± 0.5 volts.
Keep input voltage above 10.5±0.5
volts to maintain regulation.
Poor or weak
Recharge or
battery condition.
replace battery.
Inadequate power being
Make sure connection is secure.
delivered to the inverter
Use lower gauge wire. Keep
or excessive voltage drop.
wire length as short as possible.
Troubleshooting
PROBLEM: TV Interference
PROBLEM: Low Battery Alarm On All The Time
8