Clip phone 101 – Topcom 101 User Manual
Page 14
1 INSTALLATION
You can use batteries or an AC adaptor to activate the telephone display. When you install the batteries,
the telephone lines at the back of the phone have to be disconnected.
To insert the batteries, take the following steps :
• Use a screwdriver or any other flat tool to open the battery compartment.
• Put four 1,5V (AAA) batteries inside the battery compartment.
• Close the battery compartment carefully.
Note : When the “Battery empty”
symbol appears on the display, the batteries need to be replaced by new ones.
To install the phone, you have to do the following :
• Connect one end of the telephone cable to the Clip Phone 101 and the other end to the receiver.
• Connect one end of the telephone line to the back of the phone “LINE” and the other end to the
telephone line wall socket.
2 BUTTONS
1
Numerical buttons
2
Memory button
3
Memo button
4
Recall button
5
Erase button
6
Down button
7
Up button
8
Pause button
9
Mute button
10
Flash button
11
Redial button
12
Direct Memory button M1
13
Direct Memory button M2
14
Direct Memory button M3
15
Direct Memory button M4
16
Direct Memory button M5
17
Ring volume switch
18
Volume switch
14
Clip Phone 101