Toshiba DISC BDX2250KU - Manual (Page 11)

11
Connecting to a digital amplifi er/AV receiver
Connecting to network
Connections
Route the sound from this player to other device to enhance audio output.
Connect a coaxial cable from the COAXIAL DIGITAL jack on this product to the COAXIAL jack on the device. •
If your AV receiver or amplifi er has an HDMI jack, you can also connect the HDMI cable to HDMI IN jack on your AV •
receiver or amplifi er.
AV receiver / amplifier
digital audio coaxial cable
(not included)
COAXIAL
DIGITAL AUDIO INPUT
LAN WAN LAN
1 2 3 4 5
LAN
Internet
LAN cable LAN cable
Hub or broadband router
Networking equipment
(modem, etc.)
Your Blu-ray Disc™ player can be connected to your home network:
By connecting an Ethernet cable to the ETHERNET jack on the rear of your player and to a wired hub or router. Using •
a wired network provides the best performance, because the attached devices connect directly to the network and
are not subject to radio frequency interference.
By connecting through the built-in wireless device and a wireless access point or router.
•
Connecting your player to a wired router
Connect an Ethernet cable (CAT5 or better with RJ45 connector) to the • ETHERNET jack on the back of your player
and to an Ethernet jack on a hub or broadband router.
Notes:
Do not connect a modular •
p h o n e c a b l e t o t h e
ETHERNET jack.
When plugging or unplugging
•
the cable, hold the connector
on the end of the cable.
When unplugging, do not
pull on the cable. Press down
the lock tab and pull the
connector out of the jack.
Because there are various
•
connection configurations,
follow the instructions from
your telecommunication
carrier or Internet service
provider.