Toshiba RAV-SM1102AT-E - Manual (Page 11)

8
In FAN operation In all modes
Display when stopping the swing
Initial setup
Series of
operation
Fan/Heat
operation Cool/Dry
operation
ON / OFF
FAN
TEMP.
SWING/FIX TIME
MODE
VENT
UNIT SET CL
FILTER
RESET TEST
TIMER SET
ADJUSTMENT OF WIND DIRECTION
• When the air conditioner stops, the flap (adjustment plate of up/down wind direction) directs downward
automatically.
• When the heating operation is in READY states, the flap (adjustment plate of up/down wind direction) directs
upward. The swinging starts after HEAT READY status cleared, SWING is displayed on the remote
controller even if the heating operation is in READY status.
How to set up the wind direction
1
Push SWING/FIX during operation.
The wind direction changes for every push of the button.
In HEAT operation
Direct the flap (adjustment plate of up/down wind direction) downward. If directing
at upward, hot air may not come to the foot.
In COOL/DRY operation
Direct the flap (adjustment plate of up/down wind direction) upward. If directing it
downward, the dew may from on the surface of the air discharge port and may
drop down.
How to start swinging
1
Push SWING/FIX , set the flap (adjustment plate of
up/down wind direction) direction to the
lowest position, and then push
SWING/FIX again.
SWING is displayed and the up/down wind
direction is automatically selected.
How to stop swinging
1
Push SWING/WIND again while the flap is
swinging.
• The flap stops at a position when you push.
After then, if pushing SWING/FIX , the wind direc-
tion descends from the highest position.
• In COOL/DRY operation, the flap does not
stop as it directs downward.
If stopping the flap as it directs downward
during swing operation, it stops after moving
to the 3
rd position from the highest position.
Initial setup
Initial setup