Top Innovations SF-450 - Manual (Page 5)

LEARNING ABOUT YOUR STEAMER
Please refer to the picture for each point
(1) The control HANDLE on the end of the hos e sits
just before the nozzle. The HANDLE is designed
to be heat free and is safe to grasp. Use the
HANDLE to aim the direction of the steam
released from the nozzle
(2) The NOZZLE on the end of the handl e is l ocated
on the end of the steamer hose. Always hang the
NOZZLE end of the hose on the hanger rod when
not
i n use. Keep the NOZZLE po i nt the NOZZLE
downward , water may condense and drip.
(3) The R O D is designed to conveniently hang the
hose handle and also can support garments for
steaming
(4) The HOSE extends from the base of the unit Do
not pull on the HOSE w i th undo tension as
damage to the hose may result i n steam l eakage
(5) The ON / OFF switch is l ocated on the front of the
base.
(6) The WATER CONTAINER is f illed through the
removable water valve on t he bottom and should
be placed in the reservoir on the base. Avoid
spilling excess water into the reservoir as this
could cause the steamer to expel water from the
nozzle. Do not try to substitute an other water
container for the one designed for this u nit.
(7) The WATER LEVEL can be seen visually in t he
water container. Do not operate the steamer
without water in t he WATER CONTAINER.
(8) The steamer BASE houses the reservoir and
water container. It also supports the hanger rod
and hose.
(9) The CASTERS allow the unit to roll freely
(10) The E LECTRICAL CORD plugs into a standard
three-prong plug. Use only three prong UL
approved extension cords with a minimum 20-
ampere rating
(11) The DRAIN PLUG is located on the side f or
convenient drainage of the water reservoir.