beautypg.com

Mira 200, Recording a telephone conversation, Playback of the recorded messages – Topcom MIRA 200 User Manual

Page 13: Speech quality

background image

24

25

Mira 200

Mira 200

1. Press and release the MEMO

button. After the beep you can dictate your

memo message in the microphone of the base station.

2. The recording stops automatically when the maximum programmed recording time

(see 9.6.) is reached. To end the recording earlier, press the STOP

b u t t o n .

3. Your Mira 200 automatically repeats the recorded memo message. Press the STOP

button to stop the automatic playback.

9.10. RECORDING A TELEPHONE CONVERSATION

When you are having a telephone conversation with the handset of the Mira 200, this
conversation can be recorded.

Proceed as follows:

1. Press and release the MEMO

button and the recording starts immediately.

The recording time appears on the display.

2. Press the STOP

button or hang up

to stop the recording.

9.11. PLAYBACK OF THE RECORDED MESSAGES

The Mira 200 offers you two possibilities for the playback of the recorded messages:
either you can just playback the new messages or all the messages. The speaker vol-
ume can be adjusted with the volume switch on the base station.

9.11.1. ONLY THE NEW MESSAGES

The display on the base station blinks to indicate the number of new messages. Press
and release the playback

button to listen to the messages. Your Mira 200 plays

back all the new messages from the first one on.

7. Press the playback/fast forward

button to change the number (0-9).

8. After setting the remote control code, press the rewind

button again. “Cd”

appears on the display again.

9. Press the STOP

button to end the programming or the

/PROG button to pass

to the following setting.

9.8. SPEECH QUALITY

You can program the Mira 200 so that an even better speech quality of the recorded
messages is obtained.

Proceed as follows:

1. Bring the Mira 200 in programming mode until “48” or “72” appears on the display,

depending on the last setting.

2. Press the playback/fast forward

button to switch to “48” or “72”.

“48”: for a sampling rate of 4.8 kbps which gives a total recording time of 14 min-
u t e s .
“72”: for a sampling rate of 7.2 kbps which gives a total recording time of 9 min-
utes but with an even better sound quality.

3. Press the STOP

button to end the programming or the

/PROG button to pass

to the following setting.

9.9. MEMO MESSAGES

Instead of leaving written memo messages for the members of your household, you
can dictate memo messages on your Mira 200.

To record a message proceed as follows: