Topcom 1850 - Manual (Page 5)

5
EN
GLISH
TOPCOM Multifunctional Humidifier 1850
It is recommended to use soft (distilled - low-mineral) water to minimize lime scale on the
transducer.
Do not remove the water tank when the humidifier is connected to the main power.
When you remove the water tank after usage, there will still be water in the water flume.
Remove the water from the tank and flume when it is not used for a long period.
Clean the water box, spray mouth and water flume if the humidifier is not used for a long period.
Do not position the humidifier near heat sources or direct sunlight.
Do not aim the fume dispenser to furniture, electronic equipment or baby beds.
6 Operation
6.1 On/off
• Press the on/off button on the unit on the remote control to activate the humidifier. The display
lights up and, after a few seconds, the ambient humidity is displayed.
• Press the on/off button again to deactivate the humidifier.
6.2 Empty water tank
If the water tank is empty, the empty water tank indication is displayed.
6.3 Humidity level control
• Press the humidity level button to increase the humidity setting from 40% to 80%. After flashing
for 5 seconds, the LCD display shows the level of ambient humidity .
When the moisture level reaches the pre-set value, the humidifier automatically stops for five
minutes in order to test the humidity in the air.
• Instead of selecting the humidity level 40% to 80%, you can also select ‘- -’ for continuous
operation.
6.4 Warm mist
If the water gets stagnant, it will spray the stagnant water, and any bacteria it contains, into your home.
This is why it is important to clean the tank regularly and refill it with clean water when you haven't been
running it.
To avoid that bacteria are sprayed around in your room, the Multifunctional Humidifier 1850 can pre-heat
the water before it is sprayed.
It will take several minutes before the mist will feel tepid. The mist will never feel hot!
• When activating the humidifier, the warm mist function is automatically on. The warm mist icon
is displayed.
• To deactivate the warm mist, press the warm mist button .
6.5 Mist intensity
Press the mist intensity button to change the generated amount of mist. The display will indicate the
mist intensity .
6.6 Ionizer
The air ioniser is a device which uses high voltage to ionise, or electrically negative charge, molecules
of air. Negative ions help freshen and purify bad particles in the air, which are causing allergens such as
pollen, mold spores, dust, and animal dander floating in the air . They help to lift mood, alleviate
depression and seasonal affective disorder and promote a sense of well-being.
When the Humidifier is on:
•
Press the Ionizer button to start the ioniser. The ionizer icons blink on the screen.
• Press the Ionizer button again to stop the ioniser.
k
k
e
h
b
d
i
g
n
f
f