Technical specifications, Fitting under a counter, Levelling – Tricity Bendix TBDW 30 User Manual
Page 7

Dimensions
Width
44.6 cm
Height
81.8 - 87.8 cm
Max depth
55.5 cm
Max depth with open door
111.4 cm
Electrical connection
Voltage
220/240 V - 50 Hz
Motor rating during wash
200 W
Power of heating element
2800 W
Overall power
3000 W
Water supply pressure
Minimum
50 kPa (0.5 bar)
Maximum
800 kPa (8 bar)
Capacity
8 place settings
Technical specifications
7
Fitting under a counter
(kitchen worktop or sink)
By removing the machine’s worktop, you can install it
under a close fitting sink unit or a pre-existing top,
providing the dimensions of the recess correspond to
those shown in the picture.
Proceed as follows:
-
Remove the machine’s worktop by unscrewing the two
front retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting height and levelling with
the adjustable feet. When inserting the machine, ensure
that the water inlet and drain hoses are not kinked or
squashed.
Levelling
Good levelling is essential for correct closure and sealing
of the door.
When the appliance is correctly levelled, the door will not
catch on the levelling spacers on either side of the
cabinet.
If the door does not close correctly, loosen or tighten the
adjustable feet until the machine is perfectly level.
820
570-600
450
IN04
IN11
IN12