Tekkeon ET6000 - Manual (Page 10)

8
To Make Calls Using Voice Dialing
(if supported by your mobile phone)
1. Press . “Voice Dial” appears on the display and your phone is put into voice dialing mode.
2. After you hear a beep (usually between one to four seconds), speak the name of the person you wish
to call. You will hear the spoken name (if provided by your phone) and the call is automatically
connected to ezSpeak.
NOTE: The voice dial feature must be activated and the voice tag must be recorded before using this
function.
TIP: In a noisy environment where the noise may interfere with voice commands, you should dial from
the mobile phone keypad, or use any of the other advanced calling features to make the call from
ezSpeak.
To Make Calls Using Stored Number Redial
1. Press for two seconds to enter Memory mode. The last received number will appear first.
2. Press or to scroll through the numbered list of the last nine received calls.
3. Press to dial selected number. “Calling” appears on the display and the call is automatically
connected to ezSpeak.
Receiving Calls
When you receive a call on your mobile phone, both ezSpeak and your mobile phone will ring. You can
either answer the call, or reject the call and send the caller to voice mail (if available).
If the Call Waiting feature is supported by your phone, you can answer an incoming call while you are
connected on another call. In this case, the connected call is placed on hold and the incoming call is
connected. While both calls are connected, you can toggle between both.
et6000_ug_fnl 10/26/06 4:17 PM Page 8