Theta Digital Dreadnaught II User Manual
Page 16
8
17. BALANCED input jack – Channel B of two channel module.
18. SINGLE-ENDED input jack – Channel B on two channel module.
19. SURROUND REMOTE TRIGGER jack. When the rear panel SURROUND TRIGGER jack receives a 5-12 VDC
pulse the Dreadnaught II’s surround mode will change from its current status, either on or off.
20. DB9
RS232 connector. Used for connecting a system control device to the Dreadnaught II to control and monitor
its functions.
21. RJ45
RS232 connector. See DB9 RS232 connector, above.
22. STANDBY REMOTE TRIGGER jack. When the rear panel STANDBY TRIGGER jack receives a 5-12 VDC pulse
the Dreadnaught II will change its mode from either standby to operate, or operate to standby, depending on its
current mode.
23. MAIN POWER Switch. Master power switch. Disconnects AC to all circuits. It is recommended that this be left
ON at all times during regular use with the exception of whenever cables are connected/disconnected or when
the unit is not going to be used for an extended period of time.
24. Rear
panel
FUSE. If necessary to replace, use same type and rating only.
25. AC POWER INPUT.