Thiel Audio Products SS1 Subwoofer - Manual (Page 11)

LFE
Level
Rear Wall
Distance
Side Wall
Distance
LFE Output
LFE Input
Normal
Input
Normal
Output
Trigger
On
Off
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
!
THIEL SmartSub ®
Model
Ser N o
Voltage
THIEL Audio • 1026 Nandino Boulevard • Lexington, Kentucky USA • www.thielaudio.com
On
Auto
Flush Off
1.5
0.5 1.0
0
0 Off
2.0
2.0 2.5
1.0 1.5
0.5
100
60
70 80
90
50
On Replace fuse only
with same rating.
Remplacer le fusible par un
autre de la meme valeur.
Fuse
T6.3A L 250V for 120v
T3.15A L 250V for 240v
®
C US
U.S. patent 6,801,628 other patents pending
120V~ 6.3A 60Hz or
230V~ 3.15A 50Hz
Power cord plugs here Turn power on here
11
See page 14 for fuse replacement
Set this
control to
match the
distance
from the
side of the
subwoofer
to the
nearest side
wall of the
room (in
meters). Set this
control to
match the
distance
from the
rear of the
subwoofer
to the rear
wall of the
room (in
meters). This level
adjustment
functions
only for the
LFE input.
If you are
not using
the LFE
input, set
this to
minimum.
Connect an
input cable
to this
connector if
the
subwoofer is
being used
for the
processor’s
subwoofer
output. If the LFE
input is
used, this
connector
can connect
to an
additional
subwoofer. Connect an
input cable
to this
connector if
the
subwoofer is
being driven
by a
crossover or
Integrator. If the
Normal
input is
used, then
this
connector
can be used
to connect
to an
additional
subwoofer. DC voltage
(5-25 volts)
to this jack
will turn the
amplifier on
if the auto/
on switch is
set to auto.
Removing
the voltage
turns the
amp off. The On
position turns
the amplifier
on provided
that the main
power switch
is on. The
Auto position
allows the
amplifier to
automatically
turn on when
it detects an
input or a
trigger. This light will
glow green if
the amplifier
is currently
operational,
red if the
amplifier is
set for auto-
on that is not
activated and
yellow when
heat is a
problem.