Turbosound QIUCKSTAR AND RIGGING TCS-1061 - Manual (Page 3)

Quick Start Guide
TCS series
TCS series Quickstart Guide v1.0 - Page - 3
Safety Information
Safety Notes on Rigging
The Turbosound rigging system has been designed and constructed to a high standard of safety, and
tested to the most demanding of specifications. In order to ensure the highest safety standards, this
information on the assembly and safe use of rigging accessories must be understood and followed.
Only use Turbosound recommended rigging accessories, which are specifically designed for their intended purpose. Do
not use Turbosound rigging with other types or brands of loudspeakers. This practice may compromise safety
standards and Turbosound will not be responsible for damage or injury so caused. Do not modify the rigging
accessories, or use them in a way other than that described in this user manual. Rigging components supplied as part
of a complete assembly are non-interchangeable and must not be exchanged with the component parts of any other
assembly. The component parts of a Turbosound rigging accessory must only be assembled using the fasteners and
methods of assembly recommended in this guide. The use of fasteners and methods of assembly not specified or
approved by Turbosound may result in an unsafe rigging assembly. Welding, or any other means of permanently fixing
rigging components to each other or to cabinet fixing points is not allowed. Rigging assemblies must only be
assembled using the appropriate parts and fixings as specified in this manual using the specific mounting instructions.
Rigging components or assemblies must only be fixed to Turbosound loudspeaker cabinets using the cabinet fixing
points, assembly methods and fasteners specified in this guide and the specific mounting instructions. When
assembling the loudspeaker array ensure that all fixings are securely tightened before lifting the array.
Secondary Safeties
All TCS-1061 loudspeaker clusters flown in theatres, studios or other places of work and entertainment must, in
addition to the principle load bearing means of suspension, be provided with an independent, and properly rated and
securely attached secondary safety. Only steel wire ropes or steel chains of an approved construction and load rating
may be used as secondary safeties.
Safety Inspections
Carefully inspect rigging systems components and cabinets for defects or signs of damage before proceeding to
assemble a flown array. If any parts are damaged or suspect, DO NOT USE THEM.
Regular, more rigorous test and inspection of rigging components must also be carried out. Safety legislation and test
and inspection requirements will vary from country to country. In most cases, annual independent test and inspection
by a suitably approved and qualified inspector will be required. Users must ensure compliance with all applicable safety
requirements. Turbosound recommends regular safety inspections and further recommends that a logbook be kept
detailing the test and inspection history of each Turbosound rigging accessory. Always wear protective headwear,
footwear and eye protection in accordance with local regulations. Anyone involved in flying ANY sound system should
take note of the following advice:
The rigging of a flown sound system may be dangerous unless undertaken by qualified personnel with the required
experience and certification to perform the necessary tasks. Fixing of hanging points in a roof should always be carried
out by a professional rigger and in accordance with the local rules of the venue. The house rigger and/or building
manager must always be consulted.