Technika BB-129I - Manual (Page 10)

9
PLAYING A CD
You can load and play music CDs and navigate a CD using the
buttons on the remote control or the front panel.
First time use:
Lift the CD door to open the CD loading bay. •
Remove any transit packing that may be fitted to protect •
the CD player in shipping.
Selecting CD operation:
Move the • FUNCTION slide switch on the top panel to
select the CD position.
The display on the front panel will light.
Loading a CD:
Lift the CD door to open the CD loading bay. •
Holding the disc by the edges, place the disc on the •
turntable in the centre of the CD loading bay with the
label uppermost.
Gently close the CD door.
•
The unit will read the disc and display the total number of
tracks on the disc.
Removing a CD:
Ensure that the CD is stopped. •
Lift the CD door to open the CD loading bay. •
Holding the disc by the edges, lift the disc off the •
turntable and place it back in the case.
Gently close the CD door.
•
Playing a CD:
Press the • /, button.
The play symbol will appear on the display.
Pausing a CD:
Press the • /, button while the CD is playing.
The display will flash.
Stopping CD play:
Press the • . button (or STOP button on the remote
control) while the CD is playing.
The CD will stop.
Selecting tracks:
Press the • } or { button to select the next or previous
track.
NOTE:- When pressing { while playing a track, the first press
will replay the current track.
Fast search:
Press and • hold the } or { button to fast search
forward or backward through a track.
The track will search at high speed.
Repeat play:
Press the • REPEAT button to cycle through the available
repeat modes - ‘Repeat 1’, ‘Repeat all’ or ‘Repeat off’.
The mode selected will be shown on the display.
Selecting ‘Repeat 1’ will continuously repeat the current track.
Selecting ‘Repeat all’ will repeat the entire disc continuously.
Random play:
Press the • RANDOM button to turn Random play on or
off.
RANDOM will be shown on the display.
Random play will play the tracks on the disc in a random
order.
NOTE:- Random play can be set at the same time as ‘Repeat
All’ to repeat the contents of the disc in a random order.
PROGRAM PLAY
You can load a disc and store a programmed selection of up to
20 tracks to play from the disc in your preferred sequence.
To set a program:
Load a disc and wait for it to read. •
Press the • PROGRAM button (or PROG on the remote
control).
The display will show 01 briefly (the position of this track in the
program), then flash 00 PROG.
Select the track number you want to program by pressing •
the } or { button.
To save this track into the program sequence, press the
•
PROGRAM button.
The display will show 02 briefly, then flash 00 PROG.
Repeat these two steps until you have stored all the •
tracks in the program sequence.
Playing the program:
Press the • /, button to start the program playing.
The program will begin to play and the PROG will show on the
display to show that a program is being played.
Selecting tracks:
You can navigate through the tracks stored in the •
program by pressing the } or { button.