Troy-Bilt 52058 - Manual (Page 13)

11
ADJUSTING TRIMMER
HEAD ENGAGEMENT
The tension on the drive belt must be
correct for proper operation of the
trimmer head. If the tension is correct,
the trimmer head will rotate when the
Trimmer Head Control Bail is pulled
back against the handlebar (another in-
dication of correct tension is if the
engine stalls when the trimmer head
becomes bound up in very tough
material.)
A worn or loose drive belt will slip on
its pulleys, causing the trimmer head
to move slowly, or not at all, when the
control bail is engaged (belt squealing
may also be noticeable).
If the tension is too tight, the trimmer
head may rotate before the control bail
is engaged, or when there is no free
play in the control bail.
To Adjust Belt Tension
1. Stop the engine and wait for all
parts to stop moving. Adjust the posi-
tion of the two nuts on the control
cable adjustment stud (see Figure 5-2)
as described next:
a. To tighten belt tension, move the
upper nut (A, Figure 5-2) upward,
then move the lower nut (B) upward.
Tighten both nuts securely.
b. To loosen belt tension, move the
lower nut (B, Figure 5-2) down and
then the upper nut (A) down.
Tighten both nuts securely.
REQUIRED MAINTENANCE SCHEDULE
BEFORE EVERY EVERY EVERY AS
REQUIRED MAINTENANCE EACH 5 25 100 NOTED
USE HOURS HOURS HOURS
CHECK ENGINE OIL LEVEL • •
CHECK TRIMMER/MOWER LINES • 1
CHECK TRIMMER HEAD ENGAGEMENT •
ENGINE/MACHINE CLEANING • 3
CHECK NUTS AND BOLTS •
CHANGE ENGINE OIL • 2, 5
SERVICE AIR FILTER SYSTEM • 5
CLEAN UNDER DECK •
GENERAL LUBRICATION •
INSPECT DRIVE BELT •
CLEAN ENGINE DEBRIS GUARD • 4
CHECK WEAR CUP • 6
NOTE 1 – New line replacement is suggested when old line is 50% or less of original length.
NOTE 2 – Change oil after first two hours of new operation; thereafter every 25 hours.
NOTE 3 – Clean daily if used in extremely dusty/dirty conditions (see Engine Owner’s Manual).
NOTE 4 – Clean before using machine and at each fuel refill.
NOTE 5 – Service more often if used in extremely dusty or dirty conditions (see Engine
Owner’s Manual).
NOTE 6 – Replace when severe gouges exist on bottom surface.
Chart 5-1
Maintenance
5
Section
Before inspecting, cleaning or servicing the machine, shut off engine, discon-
nect spark plug wire, and make sure that all moving parts have come to a com-
plete stop. Remove ignition key on electric start models.
Failure to follow these instructions can result in personal injury or property
damage.
WARNING
NOTE: LEFT and RIGHT sides of unit are as viewed
from operator’s position behind the handlebars.
Figure 5-2: Belt tension adjustment.
B
A