Targus Wireless Remote Presenter PAUM30U / 400-0110-001C - Manual (Page 8)

8
Targus Wireless Remote Presenter
Troubleshooting
The presenter is not working or is interfering with another
remote device – what should I do?
The presenter has 256 identification codes that allow it to
operate without interference from other radio frequency
devices. The presenter and its receiver must be set to the same
identification code to function properly. To set the
identification code:
1 Using a bent paper clip or similar object, press and release
the red ID button on the top of the receiver.
Receiver
2 Within ten seconds, press and hold the presenter’s left and
right mouse buttons at the same time for two seconds, then
release both keys.
3 Press any mouse key to capture the presenter’s new
identification code.
ID button
USB
connector