TOYOTA TY-71-00-G3 - Manual

TOYOTA TUNDRA 2000-2006
TOYOTA SEQUOIA 2001-2007
(MANUAL CLIMATE CONTROL ONLY)
PART NUMBER: TY-71-00-G3
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS VSM G3
All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling
wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
#2 Phillips screwdriver, hook tools, 5/64” drill bit and drill, marking pen.
VSM G3, A Plate, J Stem, two (2) #8 1/2” screws
Right of air vent TOOLS REQUIRED:
PARTS INCLUDED:
LOCATION:
STEP 1. Locate the two air vents that are on the right and left
sides of the radio. Remove both of these air vents by inserting
the hook tool between the vents and the bezel and carefully
prying outward on the vents to remove. Set the vents aside.
Inside the vent cavities locate and remove two (2) Phillips
screws using the Phillips screwdriver. Set the screws aside.
STEP 2. Locate the three knobs that are on the climate
control. Grasp the knobs and carefully pull toward you to
remove. Set the knobs aside. Locate and remove the three(3)
Phillips screws that are behind the knobs. Set the screws
aside. Grasp the top middle section of the bezel just above
the radio and carefully pull towards you releasing the top clip.
Insert both your hands into the air vent cavities. Grasp the
bezel and pull toward you to release a series of six clips that
are behind and attached to the back of the climate control.
These clips hold the lower section of the bezel in place. When
the bezel is loose do not disconnect any wiring. Let the bezel
hang.
STEP 3. Locate the flat section of plastic to the right of the
right air vent. Place the VSM G3 over this section of plastic,
making sure that the bottom of the G3 is level. Once the G3 is
in position, mark two (2) spots for drilling pilot holes using the
two (2) holes in the G3 as a guide. Set the mount aside.
Carefully drill two (2) pilot holes using the 5/64” drill bit and
drill, making sure to not drill too deep. Place the VSM G3 over
the two pilot holes. Insert the two (2) #8 x 1/2” provided
screws and tighten.
STEP 4. Re-assemble the dash in reverse order. This completes
the installation of your VSM G3.
Note: See the Assembly Instructions for G3 Components for
additional information.
Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this VSM
G3. Pro.Fit International may not be held liable for any personal injury resulting from accident or improper installation. Pro.Fit International,
Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876
© Pro.Fit International, Eagan, MN 2008
1
2
3
See page 2 for Automatic Climate Control
Page 1 of 3
When properly installed, the metal between the ball and 2 small holes is all that is exposed.
(Some exceptions apply).
View Instruction & Updates
Online at
www.pro-fit-intl.com