Tanaka TBC-2251 - Manual (Page 7)

www.tanaka-usa.com 6 [email protected]
Owner’s Manual TBC-2211,TBC-2251,TBC-230/B
Throttle wire/stop cord
Remove the air cleaner cover. (Fig. 1-4)
Connect stop cords. (Fig. 1 -5)
Set outer receiver (1) (if so provided) into wire guide and put
throttle wire through the outer receiver. (Fig. 1 -4)
Connect throttle wire end to carburetor. (Fig. 1 -6)
Cover throttle wire and stop cords together with protective
tube provided up to air cleaner cover. (Fig. 1 -7)
Installation of blade guard (Fig. 1-8, 8B, 8C)
Install the blade guard on the drive shaft tube against angle
transmission (2) / gear case (1). Tighten the guard bracket firmly so
that the blade guard does not swing or move down during operation.
When using a trimmer head (2), locate the guard above the angle
transmission. (Fig. 1-8D, 9B)
CAUTION!
Do not attempt to install metal blade on the curved shaft trimmer.
It is very dangerous.
CAUTION!
Some blade guards are equipped with sharp line limiters. Be
careful with handling it.