Topcom BPM WRIST 2300 - Manual (Page 11)

11
TOPCOM BPM WRIST 2300
ENGLISH
11.2 PROCEDURE
1. Press On/Start Key 1 if you want to
make use of Memory Zone 1, or
Press On/Start Key 2 if you
want to make use of Memory
Zone 2.
All digits will light up for 2
seconds.
2. After all symbols appear, the
display will show a blinking"0" with
the designated Memory Zone. At
this time,the monitor is "Ready to
Measure".
3. The monitor automatically inflates
the cuff to approximately 180
mmHg, measurement will begin.
This monitor will re-inflate
automatically to
approximately 220mmHg if the
system detects that your body
needs more pressure to
measure your blood pressure.
4. When the measurement is
completed, systolic, diastolicand
pulse will be shown simultaneously
and be saved automatically in the
memory system according to the
designated Memory Zone. Up to 30
measurements can be saved per
Memory Zone.
When a mistake was detected
during measurement the Error
mark appears on the display
M1
M2