beautypg.com

Tricity Bendix SIE524 User Manual

Page 9

background image

9

NOTE: Vapours from the oven vents may in time
cause discolouration of wallcoverings behind the
appliance. For ease of cleaning it may be
preferable to tile behind the appliance.

Overhanging surfaces or a cooker hood should be
a minimum of 685mm above the hob.

It is important to ensure that the appliance is level
after installation. Levelling feet are fitted to the
appliance to accommodate uneven floors.

GENERAL NOTES ON USING YOUR
APPLIANCE

We suggest that you run the oven elements for 10
– 15 minutes at 220

o

C to burn off any residue from

their surfaces. The procedure should be repeated
with the grill for approximately 5 – 10 minutes.
During this period an odour may be emitted, it is
therefore advisable to open a window for
ventilation.

ABOUT CONDENSATION AND STEAM

When food is heated it produces steam similar to a
boiling kettle. The oven is vented to allow some of
this steam to escape. However, always stand back
from the appliance when opening the oven door to
allow any build up of steam or heat to release.

If the steam comes into contact with a cool surface
on the outside of the appliance, e.g. a trim, it will
condense and produce water droplets. This is
quite normal and is not caused by a fault on the
appliance.

To prevent discolouration, regularly wipe away
condensation and also soilage from surfaces.

For your safety wallcoverings at the rear of the
appliance should be securely fixed to the wall.

THE COOLING FAN FOR THE
CONTROLS

The cooling fan operates immediately when the
grill or top oven is switched on. It may run on after
the controls are switched off until the appliance has
cooled. Note: The action of the cooling fan will
depend on how long the grill or top oven has been
used and at what temperature. It may not run on
where the grill or top oven has been used for a
short time or at low temperatures. Do not switch
the appliance off at its power point until the cooling
fan has cooled the appliance down.

CONTROL PANEL INDICATOR NEONS

These lights indicate whether the ovens are
switched on.

The neons also indicate when the set temperature
has been reached. They will turn on and off during
use to show that the temperature is being
maintained.

If the neons do not operate as the instructions
indicate the controls have been incorrectly set.
Return all controls to zero and re-set following the
instructions for the required setting.

COOKWARE

Baking trays, oven dishes etc., should not be
placed directly against the grid covering the fan at
the back of the oven.

Do not use baking trays larger than 30cm x 35cm
(12" x 14") as they will restrict the circulation of
heat and may affect performance.