Top Innovations SP-402 - Manual (Page 21)

FIGURE 1 FIGURE 2
FIGURE 3 FIGURE 4
Q UIK S TITCH TM
SHORT
STITCH LONG
STITCH
1) Feed the thread around the Guide Bar located at the 3 o'clock position on the
Disc Thread Guide (FIGURE 1).
2) Insert the Needle Threader down through the Guide Bar that is located at the
9 o'clock position on the Disc Thread Guide (FIGURE 2).
3) Feed the slack end of the thread through the Needle Threader (FIGURE 3).
4) Pull Needle Threader (with thread inserted) back up through the Guide Bar
(FIGURE 4).
NOTE: Refer to the illustrations on the other side of this sheet for assistance in
completing the following steps.
The purpose of this insert is to supplement the information given in the "Threading
the Machine" section on pages 10 & 11 of the instruction manual. Specifically, it
is meant to clarify steps 3 & 4 by illustrating the necessary procedures in further
detail. Follow the steps below, in combination with the information given in the
instruction manual, to properly thread the machine.
IMPORTANT!
"THREADING THE MACHINE"
INSTRUCTION MANUAL SUPPLEMENT
9 o'clock
Position
3 o'clock
Position
Guide
Bar
Disc Thread Guide
3 o'clock
Guide
Bar
9 o'clock
Guide
Bar
Guide
Bar
Needle
Threader