beautypg.com

Setup and adjustment, Warning, Adjustments – Troy-Bilt 420 User Manual

Page 7

background image

5. Follow steps below to assemble the grass catcher

(if needed). Make certain bag is turned right side
out before assembling (warning label will be on the
outside).
a. Place bag over frame so that its black plastic side

is at the bottom.

b. Slip plastic channel of grass bag over hooks on

the frame. See Figure 3-5. All the plastic channels
except center top of bag attach from outside of
bag.

c. Attach center top of bag from inside of bag.

6. Follow steps below to attach grass catcher:

a. Lift rear discharge door.
b. Place grass catcher on the pivot rod. Let go

of discharge door so that it rests on the grass
catcher. See Figure 3-6.

To remove grass catcher, lift rear discharge door on the
mower. Lift grass catcher up and out, off of the pivot
rod. Release rear discharge door to allow it to close rear
opening of mower.

WARNING: Never operate mower unless the
hooks on the grass catcher are firmly seated

on the pivot rod and the rear discharge door rests
firmly against top of the grass catcher.

3

Setup and

Adjustment

Never operate mower

unless the hooks on the

grass catcher are firmly

seated on the pivot rod

and the rear discharge

door rests firmly against

top of the grass catcher.

WARNING

A

C

B

Figure 3-5: Assemble the grass catcher (if needed).

Figure 3-6: Attach the grass catcher.

Adjustments

An adjusting plate and thumb lever at each wheel
provides cutting height adjustment.
1. Depress lever towards wheel.
2. Move it to any one of the positions for desired cutting

height. See Figure 3-7. Make sure that each wheel is
positioned at the same height.

3. Release lever towards mower deck.

Figure 3-7: Use adjustment levers at each wheel to change the
cutting height.

1

2

3

B

A