Texas Memory Systems RamSan-300/320 - Manual (Page 31)

After you have finished
entering the IP, the top line
of the front panel changes
to “Subnet Mask.” Using
the same procedure as
entering the IP address,
enter the subnet mask.
The final value you must
enter is the “Gateway
Address.” If the RamSan
is on a private network and
this value is not needed,
enter the value “0.0.0.0” to
tell the RamSan to ignore
this entry.
Subnet Mask
_
Gateway Address
_
After entering all three values, the display prompts you to confirm
the command with the “↓” button.
After confirming the new IP
assignment mode, the
display indicates “Shutting
Down Network…”
followed by a success or
failure message. Then, the
display indicates “Saving
IP Config…” followed by a
success or failure message.
Next, the RamSan attempts
to start the network with
the new settings, indicated
on the front panel display
with “Restarting
Network…” Upon success,
the system displays the
new IP address on the front
panel for 15 seconds or
until any button is pressed.
Shutting Down Network...
Saving IP Config...
Restarting network...
New IP Address:
000.000.000.000
If the network fails to start, check the Ethernet connection and
contact your system administrator. If the system successfully
saved the IP configuration, you may simply select the “Restart
Network” option from the “Ethernet Setup” menu instead of re-
selecting the same IP configuration.
RamSan-300/320 User’s Manual - 27 -